Allen-Bradley 2-D Uživatelský manuál stáhnout pdf (Strana 77)

Programming

5-8

This group of parameters defines the basic operation of the drive and should be programmed before initial

operation. For advanced programming and information on specific parameters, refer to the flow chart on page

5-2 & 5-3

Setup

Parameter # 21 Factory Default “Three Wire”

Parameter Type Read & Write

This parameter selects between Three Wire and Run

Fwd/Rev control. Refer to Chapter 2, Figure 2.7 through

Figure 2.10.

Important: Power must be cycled to the drive for the

change to take effect.

Important:See Frequency Set Group for MOP explanation.

Units Text Setting “Three Wire”

“Run Fwd/Rev”

“3 W/2nd Acc” (2nd Accel)

“Run F/R 2nd A” (2nd Accel)

“3 Wire/MOP”

“Run F/R MOP”

Important:This parameter cannot be

programmed while the drive is running.

[

q S

]

Parameter # 5 Factory Default “Adapter 1”

[

q S

]

Parameter Type Read & Write Settings ‘‘Remote Pot”

0-10 ”

‘‘Preset 1”

re e 2”

This parameter is the factory default parameter for

selecting the frequency source that will supply the [Freq

Command] to the drive. [Freq Select 2] or [Preset Freq

1–7] can be selected in place of this parameter with proper

terminal block inputs. (See Chart on Page 5-29).

Important: If an adapter that is not connected is selected

as the active frequency source, the drive will fault on “Hz

Sel Fault” (F30).

Units Text

‘‘

0-10

Volt

”

‘‘4–20 mA”

‘‘MOP”

‘‘Adapter 1”

‘‘Adapter 2”

‘‘Adapter 3”

‘‘Adapter 4”

‘‘Adapter 5”

‘‘Adapter 6”

‘‘P

2”

‘‘Preset 3”

‘‘Preset 4”

‘‘Preset 5’’

‘‘Preset 6”

‘‘Preset 7”

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 171 172

Komentáře k této Příručce

Žádné komentáře

Allen-Bradley 2-D Uživatelský manuál Strana 77

Komentáře k této Příručce

Související produkty a manuály pro Čtečky čárových kódů Allen-Bradley 2-D